Rough-country 1021 Manual do Utilizador descarregar pdf

Kit Contents :

1—Straight Gear Selector

97-02 JEEP TJ STRAIGHT LOWER GEAR SELECTOR

92102100

Congratulations on your purchase of a new Rough Country gear selector. We are committed to providing you

with the best product available for the best value. Your satisfaction is our highest priority!

Rough Country recommends a certified technician installs this system. In addition to these instructions, professional

knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Check the kit

hardware against the parts list. Be sure you have all the needed parts and understand where they go. Also please

review the tools needed list and make sure you have needed tools.

PRODUCT USE INFORMATION

As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend, because of rollover possibility,

that the vehicle be equipped with a functional roll-bar and cage system. Seat belts and shoulder harnesses should be

worn at all times. Avoid situations where a side rollover may occur.

Do not add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height

of the Rough Country product purchased. We will not be responsible for any product that is altered.

NOTICE TO DEALER AND VECHICLE OWNER

Any vehicle equipped with any Rough Country product must have the “Warning to Driver” decal installed on the sun

visor or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling

characteristics.

1 2 3 4

Página 1

Kit Contents : 1—Straight Gear Selector 97-02 JEEP TJ STRAIGHT LOWER GEAR SELECTOR 92102100 Congratulations on your purchase of a new Rough

INSTALLATION INSTRUCTIONS 1. Using a 10mm socket remove the bolt from the cup holder See Photo 1, open the center console and remove the two b

6. Next remove the 4 bolts hold on the lower shifter boot with a 8mm socket. See Photo 7. 7. Using a 8mm socket remove the 9 bolts holding the shi

12. Remove the nylon bushing from the end of the stock lower gear selector and install the bushing on the Rough Country straight gear selector.

Sem comentários

Rough-country 1021 Manual do Utilizador