921253X00 2011-UP CHEVY/GM 2500 HD 7.5”NTD DROP LIFT KIT Thank you for choosing Rough Country for all of your suspension needs. Rough Country recom
49. Remove the ABS wire and clamp from the stock knuckle. 50. Install the o-ring as shown in Photo 37. 51. Install bearing assembly in lifted knuck
57. Install the stock sway bar bushings and secure with the supplied 7/16” x 3” bolts in 1253Bag3. Tighten assembly using a 5/8” wrench. See Photo 43
REAR INSTALLATION INSTRUCTIONS 1. Chock the front tires. 2. Position a floor jack under the rear differential and jack up the vehicle. 3. Place j
10. Remove the e-brake from the frame. See Photo 7. Retain the stock hardware for reuse. 11. Remove U-bolts use 27mm socket and lower the axle with
17. Reinstall the brake line on the bump stop bracket with the stock hardware. See Photo 13. Tighten using a 13mm socket / wrench. 18. Install the
OPTIONAL KICKER BAR INSTALLATION INSTRUCTIONS 1. Install kicker bracket bushing and sleeves in the kicker bars. 2. Install the supplied kicker bar
Thank you for choosing Rough Country for all of your suspension needs. POST INSTALLATION INSTRUCTIONS 1. Check all fasteners for proper torque. Che
REAR DRIVER SIDE TEMPLATE TRIM LINE
TRIM LINE FRONT DRIVER SIDE TEMPLATE
KIT CONTENTS Rear Cross Member Front Shocks (2) Dr Diff Brkt Pass Brake Line Pass. Diff Brkt Driver Side Knuckle Skid Plate Sway Bar Link (2) Fron
Kit Contents: 1253Box1: Driver Side Knuckle 1253Box2 Pass Side Knuckle 1253Box3 Dr Fr Diff Bracket Dr Rr Diff Bracket Pass Diff Bracket
INSTALLATION INSTRUCTIONS 1. Chock the rear wheels. 2. Jack up the front of the vehicle. 3. Place jack stands on the frame behind the lower contro
14. Remove the ABS wire from the bracket as shown in Photo 7 and from disconnect at the frame as in Photo 8. 15. Remove brake caliper from the rotor
20. Loosen but do not remove the lower ball-joint nut using a 24mm socket/ wrench. Strike the knuckle as shown to dis-lodge the ball joint and remove
27. Remove the passenger side diff 2 bolts using a 21mm socket. Retain the stock hardware. See Photo 19. 28. Remove the two forward driver diff fron
33. Install the rear driver differential bracket using stock bolt with supplied 12MM flange lock nut. Slightly tighten using a 18MM wrench Do not ful
43. Reinstall the lower control arm with stock hardware. See Photo 31. 44. Install supplied NTD sleeve in lower arm. See Photo 32. 45. Install NTD
Comentários a estes Manuais